» » »

Tile Accessories Hove

diy focus - A diy guide to drilling holes in tiles and fitting tile accessories. How to avoid cracking or scratching the tile. For the first time tiler, drilling into tiles may seem a bit daunting and after all of the planning and preparing, what you don't want is a cracked tile caused by a drifting drill bit. However before you start, try looking for some alternatives. You may be able to find the same size and colour tile that already has bathroom fittings in place i.e soap dishes, toilet-roll holders, towel rings etc.

Anglian Home Improvements
0800 825 0387
48 George Street
Hove
Weatherbeaters Home Improvement Centres
01273 739894
7 Silverdale Avenue
Hove
Rob Sykes Home Improvements
01273 696574
3A Quebec Street
Brighton
M & S Home Stores
01273 772602
97 Western Road
Hove
Kean Builders & Decorators
01273 323333
1 Mortimer Road
Hove
M L Banfield & Sons Ltd
01273 737622
1-2 Little Western Street
Brighton
Tinkers
01273 729523
104 Dyke Road
Brighton
Robert Dyas Ltd
01273 324881
74 Western Road
Brighton
Anglian Windows
01273 736546
Suite 5 Clarence House
Brighton
Coastal Home Improvements
01273 725090
Sussex House Industrial Estate
Hove
Data Provided by:
 

Tile Accessories

For the first time tiler, drilling into tiles may seem a bit daunting and after all of the planning and preparing, what you don't want is a cracked tile caused by a drifting drill bit. However before you start, try looking for some alternatives. You may be able to find the same size and colour tile that already has bathroom fittings in place i.e soap dishes, toilet-roll holders, towel rings etc.

Fixing an accessory tile

Decide where you would like the accessory tile to go so you can leave a space. Once all the tiles have been fixed, clean the remaining adhesive from the area you would like the accessory tile to go and leave for 24 hours. When ready apply fresh adhesive to the accessory tile press into place then use masking tape to hold until the adhesive is dry.

Drilling into tiles

If drilling is your only option, first try tapping the point of a masonry bit to break the glaze on the tile, you can also buy a tile bit that should cut through the glaze. Another way to make drilling easier is to place masking tape on the area that you want to drill, you can also buy a fitting that will make drilling more accurate. The dust from the tile may discolour the adjacent grouting so keep a cloth or hoover handy. Be careful not to put the screws in to tight as you may end up cracking the accessory tile.

Grouting

Once all the tiles are in place leave for at least 24 hours then start grouting. You can buy in the form of powder which you mix with water or you can get ready mixed. When grouting in the kitchen or bathroom be sure to get waterproof. Apply the grout covering about 1sq metre and well into the tile joints using a damp cloth, with a separate damp cloth wipe the excess grout before it dries on the tiles. To finish you may want to polish for a shining effect.

Grout whiteners

If you find the grouting becomes discoloured there are whitening products available. Make sure you clean the area well and leave to dry, remember to read the instructions as some products are not suitable for waterproof grout.

Click here to read more from DIY Extra