Staggered Stud Wall Watford

If you are planning to partition a room it is often a good idea to create some built in storage space. By creating a staggered stud partition you can quickly create alcoves in both side of the newly partitioned room which can be used for exactly this. The basic rules of constructing a staggered partition are the same as when building a straight partition, however, there are some very obvious differences.

Mark out the position of the main partition on the floor of the room and then work out where in the run you want the alcove. With a bit of thought you can make the alcove on one side of the partition form part of the alcove on the other side, meaning less work and fewer corners to build, etc. Mark out the position of the back wall of the alcove, bearing in mind that if you are planning to hang clothes in the alcove that is created, you will need to allow for a depth of around 600mm. Doing this will allow you to check that the alcoves will be large enough before you actually start fixing the sole plate and head plate in place.

If you are happy with the size and position of your alcoves, you can now cut and fit a sole plate. The easiest way to do this is to cut it the full width of the room and fix it to the floor with nails and then cut out the section which will form the mouth of the alcove. The section you cut out will be used to form the sole plate at the back of the alcove. Cut two matching pieces of wood to form the sides of the alcove and nail these to the floor at right angles to the main sole plate. Finally nail the section you cut out of the sole plate into position between the two sides of the alcove to form the back wall.

Transfer the positions, sizes and lengths of the sole plates to the ceiling using a plumb line and create a matching head plate. You can then start to fit the studs in the same way you would with a straight partition, starting against the wall and fixing at centers of 600mm (or if using narrow plasterboards, so that there is a stud at the centre and edge of each board). When you reach the first corner you will need to add some extra strength by adding a second stud with a spacer in between (see fig. 3). This not only adds strength to the corner, but also gives you something extra to attach the plasterboards to. The first stud of the side wall of the alcove then attaches to this reinforced corner. Repeat this for all of the corners of the alcove.

- Stud Wall Regulations

- Fitting Plasterboards

- Fitting Pipes in Stud Walls

- Constructing a Stud Wall